The following steps correspond with the Order Form.  The completed order form can be taken to Lowe's Home Improvement in your area or faxed/emailed to us.

1.  Determine your Wood Species Choose from MDF/Popular Combination Paintable, or Solid Oak Solid Poplar, Solid Pine or Solid Maple Stainable.  All units come unfinished.

2.  Determine your Model Size.  The Model Size is determined by the Rough Opening Width "W" (the distance between the framing studs).  Using the Specifications Chart below follow the Rough Opening Width column down until you find the Model that your measurement corresponds with.  If your rough opening does not fit a model size, your rough opening can be furred in to meet the next smallest size.

3.  Determine your Header Height.  Measure your header height "H"(the distance from the floor to the top of the rough opening.)

4.  Determine your Wall Thickness.  Take the measurement of the wall thickness including sheet-rock "D" the Elliptical will be sent out 1/8" wider than this measurement).  It is recommended that the measurement is taken from several points to determine an accurate dimension due to varying wall thickness.

5.  Determine your Collection Preference.  Hampton, New Haven, Richland, Santa Monica or Manor.

6.  Determine if Recessed Panels are desired.  Only available on wall thickness of 6 1/2" or greater.